Blog that will move you

IntroductionAt present, cement enterprises mainly rely on the loading machine and manual stacking operation, although the domestic cement industry has also appeared automatic loading and stacking […]

IntroductionAt present, DCS control system is widely used in cement industry, the system runs safely and reliably, and its central processing unit rarely fails. However, due […]

01 Fault Analysis The model of coal mill induced draft fan of a company is W4-73-15NO19F, the air volume is 100000m³/h, the wind pressure is 2200Pa, […]

01 Introduction A 4500t/d clinker cement production line of a company is equipped with a 9MW waste heat power station. The air ejector in the vacuum […]

IntroductionA company’s 5000t/d cement clinker production line was completed and put into operation in 2008. In order to achieve the goal of ecological and environmental protection […]

Introduction A company’s 2500t/d new dry clinker production line was put into operation in 2004, and the equipment has been running steadily. However, in July 2014, […]

01 Existing problems The cement combined grinding system of a company is a “one drag two” coil flow process, the roller press is HFCG160×140, the mill […]

01 problems Line 2 of a company’s raw material mill is FLSmidthATOX50 roller mill, which was put into use in July 2007. There are three rollers, […]

01 Introduction The 2,000,000 t cement production line system of a company consists of two sets of ф4.2m×13m mills, and the supporting main reducers are JS150 […]

01 Process Status Quo In response to the national requirement of eliminating backward production capacity, a company reconstructed a set of combined grinding system consisting of […]

Existing problems The raw mill model of a company is ATOX50. The grinding condition of this vertical mill is stable since it was put into production […]

Introduction A 5000t/d new dry cement clinker production line of a company uses the third generation drive grate cooler, which is divided into three stages to […]

01 Existing problems The 5000t/d clinker production line of a company adopts ZGM-113N vertical coal mill, which was put into production in March 2008. After May […]

01 Existing problems The main oil supply pipeline of the hydraulic system of the grate cooler of a company is a 50mm seamless steel pipe. Most […]

01 Existing problems A company 5000t/d clinker production line, put into production in March 2008, the production is relatively stable. Since production, we have used NC-15 […]